#!/bin/sh
#
# This is a xerox script for Laserjet Printer.
# To get use of Postscript change the Printercommand and enable the
# command at the end of this File.
#
DEV=mustek:/dev/scanner
RES=300
PAPERTYPE=letter
#PAPERTYPE=a4
PRINTERTYPE=ps
#PRINTERTYPE=lj
#
# Non-printable area (left, right, top, and bottom margins):
#
LMARGIN=0.0
RMARGIN=0.0
TMARGIN=0.25
BMARGIN=0.0
#
# Scanner-specific options:
#
DEVOPTS="--mode Gray"
#DEVOPTS="$DEVOPTS --custom-gamma=yes --gamma-table [0]0-[64]128-[255]255"
#DEVOPTS="$DEVOPTS --backtrack=yes" # needed for Mustek 12000SP
#
# Printer Command/Resolution
PRES=$RES # change this if other Res. is desired
#
# Papersize in inch
if [ "$PAPERTYPE" = "letter" ]; then
WIDTH=8; HEIGHT=10
else
# assume a4 paper
WIDTH=8.27; HEIGHT=11.69
fi
SCANWIDTH=`bc <<_EOF_
scale=3
$WIDTH-$LMARGIN-$RMARGIN
_EOF_`
SCANHEIGHT=`bc <<_EOF_
scale=3
$HEIGHT-$TMARGIN-$BMARGIN
_EOF_`
#
SCALE=`bc << _EOF_
scale=3
75/$RES
_EOF_`
if [ "$PRINTERTYPE" = "ps" ]; then
POST="pnmtops -rle -scale $SCALE -dpi $PRES | lpr"
else
POST="pgmtopbm | pbmtolj -resolution $PRES | lpr -Praw"
fi
scanimage -d $DEV \
-x $SCANWIDTH\" -y $SCANHEIGHT\" -l $LMARGIN\" -t $TMARGIN\" \
--resolution $RES $DEVOPTS | eval $POST
Generated by dwww version 1.15 on Sat May 18 12:07:48 CEST 2024.