READ(1) User Commands READ(1)
NAME
Read - Read Target Test Chart.
DESCRIPTION
Read Target Test Chart
SYNOPSIS
chartread [-options] outfile
-v Verbose mode
-c listno
Set communication port from the following list (default 1)
** No ports found **
-t Use transmission measurement mode
-d Use display measurement mode (white Y relative results)
-e Emissive for transparency on a light box
-p Measure patch by patch rather than strip
-x [lx]
Take external values, either L*a*b* (-xl) or XYZ (-xx).
-n Don't save spectral information (default saves spectral)
-l Save CIE as D50 L*a*b* rather than XYZ
-L Save CIE as D50 L*a*b* as well as XYZ
-r Resume reading partly read chart
-I file.cal
Override calibration info from .ti2 in resulting .ti3
-F filter
Set filter configuration (if aplicable):
n None
p Polarising filter
6 D65
u U.V. Cut
-N Disable initial calibration of instrument if possible
-B Disable auto bi-directional strip recognition
-H Use high resolution spectrum mode (if available)
-X file.ccmx
Apply Colorimeter Correction Matrix
-X file.ccss
Use Colorimeter Calibration Spectral Samples for calibration
-Q observ
Choose CIE Observer for CCSS instrument: 1931_2 (def), 1964_10,
S&B 1955_2, shaw, J&V 1978_2
-T ratio
Modify strip patch consistency tolerance by ratio
-S Suppress wrong strip & unexpected value warnings
-W n|h|x
Override serial port flow control: n = none, h = HW, x =
Xon/Xoff
-D [level]
Print debug diagnostics to stderr
outfile
Base name for input[ti2]/output[ti3] file
chartread September 2014 READ(1)
Generated by dwww version 1.15 on Sun Jun 16 10:18:54 CEST 2024.