NINJA(1) User Commands NINJA(1)
NAME
ninja - small build system closest in spirit to Make
DESCRIPTION
usage: ninja [options] [targets...]
if targets are unspecified, builds the 'default' target (see manual).
options:
--version
print ninja version ("1.11.1")
-v, --verbose
show all command lines while building
--quiet
don't show progress status, just command output
-C DIR change to DIR before doing anything else
-f FILE
specify input build file [default=build.ninja]
-j N run N jobs in parallel (0 means infinity) [default=#CPUs]
-k N keep going until N jobs fail (0 means infinity) [default=1]
-l N do not start new jobs if the load average is greater than N
-n dry run (don't run commands but act like they succeeded)
-d MODE
enable debugging (use '-d list' to list modes)
-t TOOL
run a subtool (use '-t list' to list subtools)
terminates toplevel options; further flags are passed to the
tool
-w FLAG
adjust warnings (use '-w list' to list warnings)
AUTHOR
This manual page was written by Gary Kramlich <grim@reaperworld.com>
for the Debian GNU/Linux system (but may be used by others).
ninja 1.11.1 September 2022 NINJA(1)
Generated by dwww version 1.15 on Sat Jun 29 02:08:49 CEST 2024.