CMP0026 ------- Disallow use of the LOCATION property for build targets. CMake 2.8.12 and lower allowed reading the :prop_tgt:`LOCATION` target property (and configuration-specific variants) to determine the eventual location of build targets. This relies on the assumption that all necessary information is available at configure-time to determine the final location and filename of the target. However, this property is not fully determined until later at generate-time. At generate time, the :genex:`$<TARGET_FILE>` generator expression can be used to determine the eventual :prop_tgt:`LOCATION` of a target output. Code which reads the :prop_tgt:`LOCATION` target property can be ported to use the :genex:`$<TARGET_FILE>` generator expression together with the :command:`file(GENERATE)` subcommand to generate a file containing the target location. The ``OLD`` behavior for this policy is to allow reading the :prop_tgt:`LOCATION` properties from build-targets. The ``NEW`` behavior for this policy is to not to allow reading the :prop_tgt:`LOCATION` properties from build-targets. This policy was introduced in CMake version 3.0. CMake version |release| warns when the policy is not set and uses ``OLD`` behavior. Use the :command:`cmake_policy` command to set it to ``OLD`` or ``NEW`` explicitly. .. include:: DEPRECATED.txt
Generated by dwww version 1.15 on Fri Jun 28 23:48:31 CEST 2024.