bridge-utils for Debian ----------------------- From ifupdown 0.6.0 we have a really configurable /etc/network/interfaces so from now on one can configure almost anything he wants of the bridge using the Debian standard way of configuring an interface, that is, if you have ifupdown installed. To be able to do that we are providing a couple of links to /usr/share/bridge-utils/ifupdown.sh, one from /etc/network/if-pre-up.d and another from /etc/network/if-post-down.d. Configuration for bridges is much easier this way. Check the manpage for bridge-utils-interfaces(5) to learn how to configure a bridge the easy way using these scripts for ifupdown. If you are configuring the bridges this way you mustn't include the interfaces you use as bridge ports on your /etc/network/interfaces configuration, bridge-utils will take care of configuring the ports for you if needed, bridge-utils won't touch the ports config at all if not needed, if you need to set something up do it using a pre-up option on the bridge interface definition. One exception for the setup of the interfaces you'll use as ports are, for example, hotplug wifi devices where you want to run hostapd on them. If you want to use hotplug devices, please always set BRIDGE_HOTPLUG to yes on /etc/default/bridge-utils, and if you need to run any commands like hostapd on the interface, always do it using a "inet manual" config. See the examples for hostapd usage. Check also the examples if you are planning to hibernate or suspend your machine as this usually breaks the bridge if the power management utilities aren't ready to cope with us. I have added examples for hibernate and pm-utils, plus a systemd service that uses the proposed pm-utils scripts to do its job, if you have other examples or suggestions or need any, contact me. NetworkManager and other similar network configuration tools can mess with the interfaces, each tool has its way to avoid this, usually on a conf file or similar, with default NetworkManager setup we can do it from the interfaces file by defining the interfaces we don't want it to use, I have added an example for this. Using a bridge over bonding interfaces can be difficult, the tested bonding setups are over active-backup, balance-tlb and 802.3ad bonds. Using other modes of bonding and a bridge over them will probably not work. Since version 1.6-1 we allow the user to specify the MTU of the bridge and try to set that MTU to the ports of the bridge so that every port has the same MTU. In current kernels the MTU of the bridge is dynamically adjusted to be the lower of the MTUs of its ports. The bridge itself won't fragment any packets anyway, packets bigger than the MTU of the bridge will be dropped. Since version 1.6-6 we support multiple stanzas of the interface usefull, for example, to describe the IPv4 and IPv6 addresses of an interface. The only requirement for this is that all of them need to have bridge_ports specified. -- Santiago Garcia Mantinan <manty@debian.org> Sun, 21 Feb 2021 22:26:39 +0100
Generated by dwww version 1.15 on Mon Jul 1 00:04:00 CEST 2024.